Fagor CNC 8070, Руководство по эксплуатации, Страница: 341 / 358

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Operating manual
CNC 8070
DDSSETUP
–Er
ro
r m
anagem
en
t–
ser
v
ic
e.
14.
(S
OFT
V03.0
X
)
307
14.6 –Error management– service.
The command bar is located at the bottom of the window. See "14.3 Command bar"
on page 302.
Disabling the errors
To disable an error of the drive, use the
ERROR LISTING
softkey of the horizontal
menu. This softkey shows the whole list of possible errors. To disable the desired
ones, checkmark the box on the left.
Then, press the
SEND
softkey to send the list to the drive. To make the error disabling
effective, execute the command DC1 (reset errors) from the command bar.
Disabling the errors requires an OEM or FAGOR access level. See "14.4 Changing
the drives accessing level" on page 304. Even then, only resettable errors may be
disabled, even if the list also shows the non-resettable errors.
This service shows the list of errors detected by the drive. The errors are shown in
the order they come up.
Once the cause of the error has been corrected, the errors may be reset with the
ERROR RESET
softkey of the horizontal menu.