Fagor CNC 8060, Руководство по эксплуатации

Страница: 62 / 172

Operating manual (MC).
CNC 8060
CNC 8065
3.
WORKING
WITH OPERATIONS OR
CYCLES
Gene
ra
l concep
ts.
·62·
(R
EF
: 1709)
3.1.6 Value applied when the value of a parameter is 0
Penetration step I=0:
When programming I=0, it assumes as step the cutting length assigned to the tool in the tool
table.
An error will be issued if the table value is also 0.
Penetration feedrate Fz=0:
When programming Fz=0, the roughing and finishing penetration takes place at half the
milling feedrate "F" selected for each operation.
Penetration angles

=0 and

=0:
In both cases, when programming 0, it takes the value assigned to the table in the tool table.
If the table value is also 0, it penetrates vertically, without inclination, 90° angle.
Finishing passes or number of penetrations N=0:
When programming N=0, it carries out the least amount of passes possible, considering the
cutting length assigned to the tool in the tool table.
In pockets and bosses (except in 2D and 3D pockets), if the table value is also 0, it checks
the roughing and finishing tools. If it is the same, the wall finishing is carried out with tangential
entry and exit at each penetration after the roughing operation.
An error will be issued if they are different.