Fagor CNC 8060, Руководство по эксплуатации

Страница: 41 / 172

Operating manual (MC).
CNC 8060
CNC 8065
O
PERATING
IN JO
G MODE
2.
Ope
rations with the axes.
·41·
(R
EF
: 1709)
2.2.4 Moving an axis to a particular position (coordinate)
Feedrate behavior
The moving feedrate depends on whether G00 or G01 is active. This feedrate may be varied
between 0% and 200% using the feedrate override switch on the operator panel. The
percentage will be applied on to all the movements carried out in G00 and in G01.
• If G00 is active, the movement is carried out at the rapid rate defined by the machine
manufacturer.
• If G01 is active, the movement is carried out at the active feedrate. If no feedrate is active,
the movement is executed at the feedrate defined by the machine manufacturer.
2.2.5 Coordinate preset
The coordinates must be preset one axis at a time. The preset may be canceled by homing
the axes one by one or by means of function "G53".
1 Select the axis to be moved using the alphanumeric keyboard. The
CNC will highlight that axis to indicate that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move
the selection until positioning on the desired one. The focus moves with
the [

][

] keys.
2 Enter the coordinate of the target point.
3 Press [START] to execute the movement or [ESC] to cancel the
operation.
X Y Z
ESC
1 Use the alphanumeric keyboard to select the axis whose position value
(coordinate) is to be preset. The CNC will highlight that axis to indicate
that it is selected.
To select the numbered axes (e.g. "X1"), select any axis and then move
the selection until positioning on the desired one. The focus moves with
the [

][

] keys.
2 Key in the desired preset value.
3 Press [ENTER] to preset the entered value or [ESC] to cancel the
operation.
X Y Z