B614
46
732998 - Rev.A_DRAFT
Tr
ansla
tion of the original instruc
tions
ENGLISH
3. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the remote
control that you wish to memorise. The LED (DL4
or DL5) on the board goes on as a steady light for
2 sec to then start flashing again for another 20
seconds during which it is possible to memorise
another remote control.
4. Wait for LED DL4 or DL5 on the board to turn off
before using the new remote control.
DS - MEMORISING REMOTE CONTROLS
1. Set the required ON/OFF combination of the 12
dip-switches on the DS remote control. Avoid set-
ting all of them to ON or all of them to OFF.
2. Press and keep pressed the + key (OPEN program-
ming) or - (CLOSE programming). After pressing
the button for about 5 seconds, the corresponding
radio LED (DL4 or DL5) will start to flash to indicate
that the radio code learning phase has started.
3. Release the button, from this moment E614 stays
in the learning phase for around 20 secs.
4. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the DS
remote control that you wish to memorise for a
few seconds. The corresponding LED (DL4 or
DL5) on the board will turn on with a steady light
for 1 second and then turn off to indicate that the
procedure was completed successfully.
5. To add different codes, repeat the procedure start-
ing from point 1.
6. For additional remote controls, use the same ON/
OFF combination for the 12 dip-switches on the
remote control that has been memorised.
DELETING REMOTE CONTROLS FROM MEMORY
!
This procedure cannot be reversed and cancels ALL the
codes of the remote controls memorised both as OPEN
and as CLOSE. The deletion procedure is only active in the
barrier status display mode.
1. Press and hold down the - button.
-
-
After holding LED DL5 down for approx 5 seconds
it begins to flash slowly, after another 5 seconds
flashing slowly and pressure maintained LEDs DL4
and DL5 begin to flash more quickly (beginning
cancellation).
-
At the end of the rapid flashing LEDs DL4 and DL5
come on and remain steady to confirm the suc-
cessful cancellation of all the (OPEN and CLOSE)
radio codes in the board.
2. Release the - button. The LEDs turn
off, indicating that the codes were
deleted correctly.
-