8
9
B614
18
732998 - Rev.A_DRAFT
22 mm
Tr
ansla
tion of the original instruc
tions
ENGLISH
5.2 PLACING THE FOUNDATION PLATE
RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Perform the operations when there is no electrical power.
!
The barrier must be installed with the base plate
- The foundation schematic appended to this manual
gives the characteristics of the foundation as pure
approximations. The schematic considers the barrier
applied to the maximum limits indicated in this manual
and under the most arduous conditions. The installa-
tion engineer is responsible for the evaluation of the
foundation materials and dimensions on the basis of
the characteristics of the ground and place of installa-
tion. Perform structural calculations where necessary.
1. Dig into the ground. Cover with concrete, ensur-
ing the tubing for the electrical cables come out.
2. (
8
) Assemble the base plate.
3. (
9
) Immerse the base plate in the foundation
leaving the surface exposed.
!
The plate must be in the centre of the plinth.
The hole for the cables to pass through must correspond
with the orientation planned for the barrier (barrier
side, door side).
The cable tubes must emerge from the hole on the plate
by around 20 cm.
Check the plate is horizontal using a spirit level.
Clean the concrete off the surface of the plate and
the nuts with washers so they can be removed when
necessary.
4. Wait for the concrete to set.
door side
B614
beam side