Alarm list panel
The alarm list panel (see figure
50
) provides information on all alarm events that are currently
active.
Figure 50.
Alarm List Panel
Alarm events that are listed can be sorted by
Type
,
Raise
Time
, and
Severity
. Position
the mouse over the desired sorting heading and left-click to change the list order.
The list is refreshed each time that you click the
Alarms
tab or change the sorting criteria.
Alarm types and descriptions
Table 11.
Encoder Alarm Type and Description
Alarm Type
Description
Action
Default Settings
Encoder Alarm
No
source
No source is present at the input.
Check the input
connection; is there
an output on the loop
through connector?
Critical, reporting
Bad
source
syncs
Source is present, unrecognized due
to bad sync measurement.
Critical, reporting
No
SDI
source
lock
Source is present, unable to lock.
Critical, reporting
Unsupported
SDI
Mode
Source is present, mode is not
supported.
Critical, reporting
Unsupported
Mode
Not applicable to VNC 325.
N/A
Bad
Source
Not applicable to VNC 325.
N/A
Analogue
Phasing
error
Not applicable to VNC 325.
N/A
Hardware
encoding
error
The hardware is unable to encode
the input signal.
Critical, reporting
Unsupported
audio
source
Not applicable to VNC 325.
N/A
Data
rate
overload
The compressed data rate is too
high.
Increase the
compression or
reduce the required
bit rate
Critical, reporting
Network
overload
The network is dropping too many
packets.
Warning,
reporting
VN-Matrix 325 Serial Digital Over IP CODEC • Alarms and SNMP
61
