Device summary panel
This panel consists of the following fields:
•
Name
— This field displays the name of the
device. You can change the name of the
unit to a more meaningful value for your
installation as follows:
1.
Highlight the existing device name.
2.
Type the new name.
|
3.
Click the
update
button.
NOTE:
Spaces within names can cause issues when controlling the system
using a third-party control system. Extron recommends avoiding spaces
within names..
•
Serial Number
— This read-only field displays the serial number of the device,
information is required when upgrading the licence on a device.
•
Device Status
— This read-only field displays either of the following messages:
•
Active
— The device is present and operating.
•
Inactive
— The controller cannot contact the device. It may be powered down or
the network cable is unplugged.
•
IP address: port
— This read-only field displays two pieces of information:
•
The IP address that is assigned to LAN port 1.
•
The port numbers that have been configured for send and receive of UDP control
information. By default these are 9001 (send) and 5432 (receive).
•
Link Status
— This read-only field displays the condition of the Ethernet network link to
the controller in one of the following messages:
•
Good
— There is little or no control data packet loss.
•
Fair
— There is a small amount of control data packet loss.
•
Poor
— A bad network link exists.
Licensed features panel
This panel consists of the following read-only
fields, which provides a description of features
that are enabled on the device:
•
Video
— For the VNC 325, this field always
reads
3G-SDI
.
•
Audio
— For the VNC 325, this field always reads
16
.
The licence management button opens the License page where additional features may be
enabled.
VN-Matrix 325 Serial Digital Over IP CODEC • Operation
35
