Configuration Selections
NOTES:
•
In a typical installation, you:
•
Must
change the address (
2
or
12
), netmask (
3
or
13
), gateway address
(
4
or
14
), and controller IP (
7
).
•
May
need to change the boot method (1 or 11).
•
Most installers do
not
need to change the other selections. If you do change
settings, note the existing values before the change in case you need to
change back.
•
Options
0
through
6
are the settings for LAN port 1 (the RJ-45 port).
•
Options
10
through
16
are the settings for LAN port 3 (the optical port).
•
Options
7
through
9
,
17
, and
18
are controller related.
•
Selections marked with an asterisk (
*
) in options
0
and
10
below are the
default VNC 325 hardware settings and the correct selection in most cases.
Table 5.
Configuration Selections
LAN Port Specific Options
Option
Function
Comments
0
Speed/Duplex:
LAN port 1 link speed
Allows you to set the speed of the RJ-45 LAN port manually
using the following subselections:
*
1. auto_10_100_1000
2. auto_10_100
3. fixed_1000F
4. fixed_100F
5. fixed_100H
10
Speed/Duplex:
LAN port 2 link speed
Allows you to set the speed of the optical LAN port manually
using the following subselections:
6. fibre_auto_1000
*
7. fibre_fixed_1000F
1
and
11 Boot
method:
Set
static
or
dhcp
Entering
1
(
11
) toggles this option. When DHCP is selected
items
2
(
12
) through
5
(
15
) are not accessible.
NOTE:
Extron recommends that you use static IP addresses.
2
and
12 address:
Set the local address
of the LAN port
•
Standard Ethernet IP addressing rules apply.
•
Manually enter the IP address for the port; use
no
leading
zeroes. For example: 192.168.0.1 is valid, 192.168.000.001
is
not
valid.
3
and
13
netmask:
Set the appropriate
subnet mask for the
network.
•
Standard Ethernet subnet rules apply.
•
Manually enter the IP address for the port;
use no leading
zeroes
. For example: 255.255.10.0 is valid, 255.255.010.0
is not valid.
VN-Matrix 325 Serial Digital Over IP CODEC • Installation and Setup
19
