Extron electronics SMD 101, Руководство пользователя

Страница: 76 / 162

1. Click the Advanced Configuration tab above the navigation bar (see figure 63 on
page 66).
2. Click the Connection icon on the navigation bar.
The
Ethernet Settings
panel opens (see figure 65).
GRPDLQFRP GRPDLQFRP
Figure 65. Ethernet Settings Panel
3.
In the
Ethernet Settings
panel, select (check) Use DHCP (
1
).
With DHCP selected, you cannot enter IP addresses into the fields in this section.
The fields are inaccessible, but they can display the IP addresses and subnet mask
assigned by the DHCP server.
NOTE: The DHCP assigned gateway and DNS addresses are retained after the
DHCP option is deselected. Both can be reset using the reset button on the rear
panel of the SMD 101 (see
SMD 101 Rear Panel Reset on page 13) or by
using the
Device Reset
embedded web page (see Reset Device on page 85).
4. In the Host Name field (
2
), specify the unit name of this SMD 101 device, if desired.
The default name is a combination of the model name (SMD 101) and the last half of
the MAC address for that unit. It can be changed to any alphanumeric name up to
63 characters. The first character must be a letter. Letters, numbers, and hyphens are
allowed. Spaces, slashes, and symbols are not permitted.
5. Click Save (
4
) to save the settings or click Cancel to discard changes.
To reset all settings to the factory default values:
1. In the Ethernet Settings panel, click Reset to Default (
3
).
2. Click Save (
4
) to set all IP addresses to the factory defaults, or click Cancel to keep
the existing IP settings.
figure 66
SMD 101 • Web-based User Interface 69