Profiles for PHOENIX MIG/MAG systems
Profiles for the CAN DeviceNet module
Item No.: 099-008225-EWM01
53
7.3.2
Profile 1 (switch position 1)
The module uses a data capacity of 5 words (10 bytes) for the input data and 6 words (12 bytes) for the
output data, distributed across 2 connections.
The following data with 4 bytes is assigned to connection 1 (output 1):
Actuation data
Byte
no.
Bit no.
Function
Description
0
0&1
Select operating mode
Bit allocation:
Bit1 Bit0
0 0
0 1
1 0
1 1
Select between non-latched/special non-latched
Non-latched operating mode
Not used
Not used
Special non-latched operating mode
0
2
Select welding mode
Bit allocation:
0
1
Select between normal/pulse welding
Normal welding active
Pulse welding active
0
3
Check monitoring function
Bit allocation:
0
1
Activate/deactivate welding parameter monitoring
Monitoring deactivated
Monitoring activated
0 4 Start
Bit allocation:
0
1
Start signal to initiate the welding process
Signal stop on system
Signal start on system
0 5 Robot
ready
Bit allocation:
0
1
Safety signal for rapid shut-down
No ready message from robot, no start possible,
rapid shut-down carried out in the process
Robot ready message, start is possible
0
6
Gas test 1
Bit allocation:
0
1
Manual check of the process gas supply
Gas supply off
Gas supply on
Bit allocation:
0
1
Manual check via the blow-out valve
Blow-out valve off
Blow-out valve on
1 0 Inching
Bit allocation:
0
1
Signal for wire inching function on the wire feed
drive
Inching off
Inching on
1 1 Position
search
Bit allocation:
0
1
Activates the position search function for the
workpiece
Position search off
Position search on
1 2 Reverse
inching
Bit allocation:
0
1
Signal for reverse wire inching function
Reverse inching off
Reverse inching on
