EPRO NVR Series
104
5.4.5.3 PTZ
You can configure the PTZ settings on this page.
Channel:
Select the channel connected with PTZ camera.
Signal Type:
Select
Digital
for the connected PTZ camera.
Protocol:
Select PTZ protocol, choose from the following protocols. (Note: All cameras on the RS-
485 bus must use the same protocol).
Baudrate:
This field is to set the speed at which is used to transmit instruction or information
through the RS-485 port on the NVR.
Data Bit:
This field is the data bit at which you will be transferring.
Stop Bit:
This field is to set the stop bit for the RS-232 connection.
Parity:
This field is to select the parity level at which you will be connected.
Address:
Input the ID address of the PTZ camera. Note this address should match the one set up
on the PTZ camera.
Copy:
You can apply the same configurations from one channel to the desired channels. Click
the
Copy
button, the below channel selection field appears. Select a desired channel (or All),
click the
Copy
button, the selected channel(s) will be applied with the same configurations.
Click
Save
to save the settings or
Refresh
to refresh the page.
