EPRO NVR Series
100
5.4.4.2 Alarm
You can configure the Alarm setting on this page.
Alarm In:
Select an alarm input from the drop-down list.
Alarm Type:
Select an alarm type.
Normally-Open
or
Normally-Close
. If you want to disable
the alarm, select
Off
.
Buzzer:
Set up the time for buzzer to sound when an alarm is triggered.
Latch Time:
Set up the time for buzzer to sound when an alarm is triggered by external
sensor.
Show Message:
Check the box to enable the function. When an alarm is triggered, an alarm
message will be displayed on the live screen.
Send Email:
Check the box to enable the function. When alarm is triggered, the NVR will
send an email alert to the receiver. Note that for this function to work, you have to set up
the Email function in advance (refer to
5.4.4.2 Email
).
Full Screen:
Check the box to enable the function. When alarm is triggered, the
corresponding channel with the alarm will be switched to full screen on the live screen.
Alarm Out:
Check the box to enable the alarm output.
Enable Record:
Check the box to enable the post recording function. You can further set up
the post recording time when alarm events occur.
Post Recording:
Select a post recording time when alarm events occur.
Record Channel:
Check the All checkbox to select all channels. When an alarm event occurs,
the selected channel(s) will be recorded.
IP Channels:
Check the IP Channels checkbox to select all channels or check the desired
channel checkboxes. When an alarm event occurs, the selected channel(s) will be recorded.
Copy:
You can apply the same configurations from one channel to the desired channels. Click
the
Copy
button, the below channel selection field appears. Select a desired channel (or All),
click the
Copy
button, the selected channel(s) will be applied with the same configurations.
