EVA MAJOLICA LINE, Инструкция по эксплуатации

Страница: 47 / 90

46
10. MICRONOVA ELECTRONICS WITH LCD DISPLAY
10.5.4 Stove switching-off during working mode alarm
The alarm is triggered when, during normal working mode, the flame goes out and the fume temperature falls below the minimum
threshold set by Pr13 parameter (see
figure 30 ). The stove switching-off phase starts immediately.
fig. 30
10.5.5 Auger tube safety pressure switch alarm
If the pressure switch (meter pressure) detects a value below the trigger threshold, it immediately switches off the Auger tube (to
which it is connected in series) while the control board acquires this change in status through the AL2 clamp in CN4. The message
“Alarm Dep Fail” appears on the display and the stove is immediately switched off.
fig. 31
10.5.6 General thermostat alarm
If the general safety thermostat detects a value exceeding the trigger threshold, it
immediately switches off the Auger tube (to which it is connected in series), while the
control board acquires this change in status through the AL1 clamp in CN4. The message
ALARM SIC FAIL appears on the display and the stove is immediately switched off. Unscrew
the black cap on the back of the stove and press the button to reset the contact.
fig. 32
10.5.7 Damaged exhaust blower alarm
Whenever the exhaust blower stops working properly, the stove switches off immediately and the message
ALARM FAN FAIL appears
on the display.The stove switching off phase starts immediately.
fig. 33