EVA MAJOLICA LINE, Инструкция по эксплуатации

Страница: 30 / 90

29
09. MICRONOVA ELECTRONICS WITH LED DISPLAY
09.4 User functions
09.4.1 Stove switching on
Hold down P4 for a few seconds to switch on the stove. The display shows that the stove is on.
The stove goes into the pre-ventilation/pre-heating phase for 90 seconds, then it enters the pre-load mode for the period of
time indicated by Pr45 parameter. Meanwhile, the Auger tube rotates and continues to load pellets. At the end of the period
of time set by Pr45 parameter, the system goes into the waiting phase whose duration is defined by Pr46 parameter. Then the
loading phase begins at the speed set by Pr04 parameter. The Auger tube ON LED is on indicating that the Auger tube is working.
The ignition plug switches off when fume temperature exceeds value under parameter PR13, increasing by a gradient of approx.
3 C°/ minute.
09.4.2 Pellet manual loading
Press P5 and P6 buttons simultaneously to load the pellets. This function is available only when the stove is
switched off and cold.
09.4.3 Fire on
Once fume temperature has reached and exceeded PR13 parameter value, the stove goes into the switching on mode: In this phase
emperature stabilises for a period of time set by PR2 parameter. If problems occur during this phase, the stove stops and the following
error message is displayed.
09.4.4 Working mode
Dopo che la temperatura dei fumi ha raggiunto e superato il valore contenuto in PR13 e lo ha mantenuto per almeno un tempo
PR02, la stufa passa nella modalità lavoro che è quella normale di esercizio. Il display superiore visualizza la potenza impostata
con i tasti P5
e P6 e quello inferiore la temperatura ambiente.
N.B.: : you can jump directly to working mode by holding down P6
button for approx. 2 seconds.
Press P1 button to display fume temperature and exhaust blower speed.
09.4.5 Changing set heat output
When the stove is in working mode, the heat output can be changed by pressing P6 (increase) and P5
(decrease) buttons. The upper display shows the set heat output.
09.4.6 Changing set room temperature
Press SET button (P3) to change room temperature and visualise the set room temperature (temperature SET).
Press P1 and P2 buttons to increase or decrease, respectively, the temperature value.
The new value is saved after approx. 3 seconds and the display goes back to normal.
Press
P3 button (SET) to visualise the set room temperature (set temperature).
Which remains on the display for about 2 seconds.
09.4.7 Stove switching off
Hold down P4 button for approx. 2 seconds to switch off the stove. “OFF” appears on the upper display, while the lower
display shows current time.
Room temperature reaches the set value (SET temperature)
When the set room temperature value is reached, the stove heat output is automatically set to the minimum value. ECO
(Economy) message appears on the upper display and the room thermostat LED switches on. The Auger tube motor stops and the
exhaust blower speed increases. The exchanger blower remains on until the fume temperature reaches a value below the preset
PR15 value. The exhaust blower switches off after approx. 10 minutes. Depending on the version, it may be necessary to wait the
period of time set by Pr73 parameter before switching on the stove again. During the wait, P4 button is
inactive and the
following message appears asking users to wait until the end of the switching off phase.
The same happens whenever the fume temperature exceeds the maximum value set by Pr14 parameter. Once the temperature
falls again within the set range, the stove goes back to the normal working mode.