EVA MAJOLICA LINE, Инструкция по эксплуатации

Страница: 78 / 90

13. MICRONOVA ELETRONICS WHIT REMOTE CONTROL
77
13.3 User functions
Standard functioning of a control board properly installed on a forced air pellet stove is described below with reference to the
functions available to users. The indications listed below refer to a control board fitted with programmable thermostat. The technical
setting mode is described in detail in the following sections.
Before switching on the stove, the control board display is as in figure 16 .
fig. 16
13.3.1 Start-up phase
The stove performs all the steps of the start-up phase according to the parameters concerning its levels and times.
fig. 17
13.3.2 Start-up phase
The stove performs all the steps of the start-up phase according to the parameters concerning its levels and times.
13.3.3 Ignition failure
The alarm is triggered when, after the period of time set by Pr01, the fume temperature has not reached the minimum value
admitted (Pr13 parameter) with a gradient equal to 2°C/min.
13.3.4 Working mode
At the end of the start-up phase, if no problems occurred, the stove enters its normal working mode.
Exchangers are enabled if the fume temperature is higher than Pr15. Exchangers no.2 and 3 start working only if they were previously
enabled.
fig. 18
FUMI
room temperature
time clock
dialogue heat output
room temperature time clock
dialogue
heat output
room temperature
time clock
dialogue heat output