EVA MAJOLICA LINE, Инструкция по эксплуатации

Страница: 58 / 90

57
11. N100 MICRONOVA ELECTRONICS WITH 3-BUTTON LED DISPLAY
11.3.6 Changing set room temperature
Press P1 button to change the set room temperature.
The display shows the set room temperature (SET temperature value). Press P1 and P2 buttons to decrease or increase, respectively, the
temperature value. The value is saved after approx. 5 seconds and the display goes back to normal. Otherwise, press P3 to exit. (
figure
9)
figure 9
11.3.7 Room temperature reaches set value (SET temperature value)
Once the set room temperature value has been reached, the stove heat output is automatically set to the minimum value. During this
phase the display shows the message "Modula".
(figure 10)
If room temperature falls below the set value (Set temperature value), the stove will go back to the "Lavoro" mode and to the
previously set heat output (Set heat output value).
figure 10
11.3.8 Stand-by
When enabled in the menu, the Stand-by function allows the stove to be switched off after complying with the following conditions.
It is enabled if the room temperature exceeds the relevant set value (Set room temperature value) during the period of time set by
PR44 parameter to which PR43 parameter must be added. The message "Go-standby" appears on the display followed by the minutes
left.
(figure 11a)
figure 11a
At the end of the period of time set by PR44 parameter the message "Attesa raffredda" will appear on the display. During this phase
the Auger tube is off (Auger tube LED off), the exchanger switches off once the threshold set by PR1 5 parameter has been reached and
the ON/OFF LED flashes.
(figure 11b)
figure 11b
22,5
c
MOD
GO-S
ATT