ETC transtechnik FDX2000, Руководство по эксплуатации

Страница: 16 / 42

D01, Dimmer type.
It is possible to set the dimmer type individually for each dimmer
Dimmer type D01
1-96: Dimmer
Open
•
Hit the
[ESC]
button until the main menu appears
•
Use
[PAGE]
or the encoder to scroll to the
M06
Dimmer menu
•
[EDIT]
takes you to the most recently opened
Dxx
dimmer menu
•
Use
[PAGE]
or the encoder to scroll to the
D01
Dimmer type menu
Settings
Dimmer
No special features, any dimmer curve may be selected, see
page 12
Nondim
Switch through the entire sinusoidal curve without phase control.
The on/off switch points are set in the
D06
Switch point menu see
page 14
Blind
No dimmer attached
HMI
As
Nondim
, but also takes into account the switch-on time of the
devices for the error messages
DimSwitch
Select switch/dimmer mode by additional control channel
DimHMI
Same as DimSwitch, for HMI application
In “DimSwitch” mode, a dimmer has assigned an additional DMX control parameter, which is used to
switch between “Dimmer” and “Nondim” operation. Use dimmer menu D01 “Dimmer type” to select
DimSwitch mode.
In DimSwitch mode, a normal 8-bit dimmer uses two successive DMX addresses:
DMX address x: dimmer output control 0-100% (DMX range 0-255), or Nondim control
(0 = off, 255 = on)
DMX address x+1: operating mode: 0 = Nondim, 255 = Dimmer
A 16-bit dimmer uses three successive DMX addresses:
DMX address x: MSB dimmer output control 0-100% (DMX range 0-255), or Nondim control
(0 = off, 255 = on)
DMX address x+2: LSB dimmer output control (DMX range 0-255), unused in Nondim mode
DMX address x+1: operating mode: 0 = Nondim, 255 = Dimmer
Similarly, the “DimHMI” mode can be used to switch between “Dimmer” and “HMI” operation. Use
dimmer menu D01 “Dimmer type” to select DimHMI mode.
Note: the new operations modes DimSwitch and DimHMI can be used with all types of FDX2000 dimmer
modules (DP90, DP90+, DP90S).
D02, Dimmer curve
The dimmers are controlled using characteristic curves. A curve assigns each output level (e.g. 50%) to
a specified 'real' dimmer level. The dimmer curve can be used to modify the dimming behavior of a
spotlight to the given requirements (e.g. to come on when a particular threshold value is achieved, unlike
linear control).
Each dimmer can be assigned a dimmer curve individually. Prerequisite: 'Dimmer' has been selected in
the
D01
Dimmer type menu (not
Nondim
, or
Blind
).
Open
•
Hit the
[ESC]
button until the main menu appears
•
Use
[PAGE]
or the encoder to scroll to the
M06
Dimmer menu
• [EDIT]
takes you to the most recently called
Dxx
dimmer menu
•
Use
[PAGE]
or the encoder to scroll to the
D02
Dimmer curve menu
– 12 – FDX2000 Vers. 4.0.0