ETC IRIDEON, Инструкция по установке и эксплуатации

Страница: 55 / 84

Irideon Control Installation and User Manual 51
Step 7: Remove the four screws from the back of the display and lift off
the spring holders.
Step 8: Remove and replace the LCD taking care to ensure the lens
remains in place between the LCD and the bezel.
Step 9: Replace the spring holders.
Step 10: Thread the four screws through the spring holders, LCD,
faceplate, and into the bezel, sandwiching the lens in place and
securing the display.
N o t e :
Do not over tighten as damage to the display may result.
Step 11: Reconnect the ribbon cable to the display PCB.
Step 12: Position the center front display panel so that the push buttons
and DB9 connector extend through the panel. Secure with the
four screws removed in Step 3 above.
Step 13: Replace the left and right front panels and secure in place with
the screws removed in Steps 1 and 2 above.
LIQUID CRYSTAL DISPLAY
CIRCUIT ASSEMBLY
BEZ EL
SPRING
HOLDER
LENS