ETC IRIDEON, Инструкция по установке и эксплуатации

Страница: 32 / 84

28 Installation
Step 2: Remove the female portion of the terminal strip and attach
wiring utilizing the following pin/wire code:
a. P2 is not used on the DMX Interpreter.
b. 3-pin Data Terminal Strip P3 on DMX Interpreter feeds
luminaire data run # 2 (fixture addresses 32 thru 62):
c. 3-pin Data Terminal Strip P5 on DMX Interpreter feeds
luminaire data run # 1 (fixture addresses 01 thru 31):
d. P7 on DMX Interpreter is not used.
e. Terminal Strip P9 on DMX Interpreter is used for DMX input
from console:
Step 3: Connect AC power as shown:
International Standard: Neutral = Blue; Line = Brown; Ground = Grn/
Yellow; Neutral = Blue
Step 4: Address the DMX Interpreter rotary switch to the desired
starting address.
Step 5: Replace the front covers of the DMX Interpreter.
Pin Wire (Cat 5) Wire (Belden 9729)
data + White/Orange Red
data - Orange Black
Gnd Brown Drain