ETC IRIDEON, Инструкция по установке и эксплуатации

Страница: 26 / 84

22 Installation
b. Connect AC power to the AC terminal block following the
label chart inside the ATC:
Step 3: If your installation includes Remote Stations, continue the single
daisy chain run for the Data and DC Power to the next station.
Step 4: Using a small screwdriver, set the two rotary switches found on
the ATC’s Contact Closure station to the fixture address
assigned to the ATC. This address information should come
from the same source as the luminaire addresses.
Step 5: Replace the ATC front panel.