Using the Control Panel Menu
207
Media Tension
0 to 40
Increase tension if creases appear in the media during printing. The
higher the value, the greater the tension.
Media Suction
0 to 10
When media is waved on the platen, increase the
Media Suction
.
The higher the value, the greater the suction.
If graininess or out-of-focus characteristics are detected in printing
results obtained using thin or soft media or if the media is not fed
normally, reduce the
Media Suction
.
Head Movement
Data Width
Choose the range in which the print head moves during printing.
Data Width
restricts print head movement to the printed area.
Restricting the extent of print head movement increases print
speed.
If
Printer Full Width
is selected, the print head will move the full
width of the largest media supported by the printer. Select this
option for more even print results with less variation.
Printer Full Width
Tension Measurement
Periodically
Choose
Periodically
or
Every page
to have the printer
automatically monitor and adjust media tension during printing for
optimal results,
Off
to disable automatic tension adjustment.
Periodically
is recommended in most circumstances.
Selecting
Every Page
enhances the accuracy of the
Tension
Measurement
for the optimal adjustment, but the printing time is
longer than when
Periodically
is selected.
The printer may however be unable to adjust tension appropriately
for some media, resulting in excessive slack or other maladjustments
that cause printing problems, in which case you should select
Off
.
Note, however, that
Off
may result in unusually large margin
between pages. In addition, printing may not stop and the inside of
the printer may become stained. Observe the following precautions:
Do not print at the end of a roll
Do not select
Off
for
Media End Check
.
Every Page
Off
Multi-Strike Printing
Off
Choose the number of times each line is printed. For high-density
printing using backlight film, increase the frequency.
2 to 8
Feed Speed
Auto
Auto
is recommended in normal circumstances. If this option is set
to
Auto
, media is fed at the optimal speed depending on the
number of printing passes.
Select
Lv1
for media that tends to stick together and for thin media
that is easily creased or torn.
Select
Lv2
for faster printing. Note, however, that the feed speed will
not change if the number of passes is large.
Lv1
Lv2
Roll Type
Printable Side Out
This option is set based on the setting you selected when you
loaded the media.
Printable Side In
Restore Settings
Yes, No
If
Yes
is selected, configured media settings are returned to the
default.
Item
Parameter
Explanation
Содержание SureColor S50675
Страница 1: ... Epson SureColor S30675 S50675 S70675 User s Guide ...
Страница 105: ...Basic Operations 105 8 When loading banner media attach three counter weights to both ends of the tensioners ...
Страница 169: ...Maintenance 169 Grasp the cleaner as shown and lift it from the printer 4 Insert a new wiper cleaner ...
Страница 170: ...Maintenance 170 Place it on the attachment point and press down until you hear a click 5 Remove the wiper ...