Item
Parameter
Explanation
Fan
Off
Set the heater to
Off
, and by setting the Fan to
Low
or
High
so media is
dried after printing by only the fan operating at the set level. Use this if the
media could be damaged by the heater during drying.
Low
High
Drying Action
Auto
The printing and media feeding time operations are adjusted
automatically or according to the set drying time.
Follow Drying Time
Setting
Drying Time
Set the length of time to pass through the dryer. The media passes
through the heater's range (600 mm [23.62 ft.]) in the dryer for the set time.
You can set it for each number of passes.
The time needed for the ink to dry varies with ink density and the media
used. If, in the print results, the ink blurs or runs on the media, set a longer
Drying Time.
Increasing the drying time increases the time needed to print.
300x600dpi -1.1pass
0 to 200 sec
300x600dpi -1.5pass
0 to 200 sec
300x600dpi -2.1pass
0 to 200 sec
300x600dpi -3.1pass
0 to 200 sec
600x600dpi -2.1pass
0 to 200 sec
600x600dpi -2.5pass
0 to 200 sec
600x600dpi -3.1pass
0 to 200 sec
600x600dpi -4.3pass
0 to 200 sec
600x1200dpi
-5.0pass
0 to 200 sec
600x1200dpi
-5.0pass HD
0 to 200 sec
1200x1200dpi
-9.0pass HD
0 to 200 sec
Proceed to Drying after
Print
Off
Select whether to feed (
On
)/not feed (
Off
) the printed areas to the dryer to
dry when printing is complete.
On
Platen Gap
Set the Platen Gap (the distance between the print head and the media).
The default setting of
2.0
is recommended in most situations. If the print
results are scratched or smudged, they may be improved by setting
2.5
.
However, choosing a larger gap than required may result in ink stains
inside the printer, reduced print quality, or shorter product life.
1.7
2.0
2.5
SC-F10000H Series/SC-F10000 Series User's Guide
Control Panel Menu
165
