H
Move to the front side, and while holding the tabs
of the media edge plate on both sides, move the
plate to the top edge of the media.
Adjust so that the edges of the media are aligned
with the center of the triangular holes in the
media edge plates.
The media edge plates prevent the media from
riding up and keep fibers on the cut edge of the
media from touching the print head. Load
correctly.
I
Close the front cover, and then move the left and
right lock levers inward.
J
Set the media information on the screen, and
press
OK
.
Do the following settings here.
❏
Media: Set the media to use for printing
❏
Roll Winding Direction: How to wind the
loaded media
❏
Media Length: Length of the loaded media
❏
Media Detection: How to detect the width of
the media
When you select Media Settings while no Media
Type is set in
Media
, the screen to select Media
Type appears. Select the Media Type using the
paper weight of the loaded media as a guideline as
shown below. The paper weights of each Media
Type shown in the screen are typical values.
Media Type
Paperweight (g/m
2
)
Ultra-Thin
39 or under
Thin
40 to 56
Med-Thick
57 to 89
Thick
90 or over
In
Media Detection
, set
Width Detection
.
Normally, leave this
On
.
See the following for details about Media
Detection.
U
“General Settings menu” on page 152
Press
OK
, to start operations, such as detecting
the loaded media.
Removing the Take-up
Roll
Follow the steps below when replacing the media.
1. Set Information Printing at Media Cut.
2. Cut the media.
3. Remove the media.
SC-F10000H Series/SC-F10000 Series User's Guide
Basic Operations
87
