Printed side out
A
While pulling the center section of the media
straight down, affix the media to the take up roll
core with commercially available adhesive tape.
c
Important:
Affix the media to the take-up roll core with the
media pulled tightly. If media is affixed loosely,
the media may move around during take-up.
B
Hold down the near side of the media feed switch
to feed enough media for a single wrap around
the take-up roll core.
C
Hold down the Manual switch on the
side
to take-up the media for a single wrap around the
core.
D
Flip the Auto switch to
.
E
Confirm that the media is attached without
looseness.
If the tension on the left and right of the media is
different in the areas shown in the illustration
below, the media will not be taken up correctly.
When one side is loose, restart the procedure
from Step 1.
Note:
You can confirm differences in tension by lightly
tapping both edges of the media as shown in the
illustration below.
F
Hold down the near side of the media feed switch
until both edges of the media are taken up and
wrap around the core once or twice.
SC-F10000H Series/SC-F10000 Series User's Guide
Basic Operations
82
