12. If you use the front slot, attach the front paper guide with
the continuous paper positioned as shown below. Then
close it.
If you use the rear slot, replace the paper guide and make sure
the edge guides are together in the middle of the paper
guide.
13. Turn on the printer.
14. Remove any slack in the paper and adjust the top-of-form
position (the position where the printer will start printing) by
pressing the
LF/FF
button or using the micro adjust feature.
(To use the micro adjust feature, see “Adjusting the
Top-of-Form Position” on page 2-37.) The printer will start
printing at the current position without advancing the paper.
c
Caution:
T
Never use the knob to remove slack in the paper or to
adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
T
Always remove any slack from the paper; otherwise
print quality may be reduced.
G3-19-AA
L
Sun-G+
Rev.C
A5 size
Chapter 2
97/11/17
pass 3
2-28
Printing on Continuous Paper
