Epilog Fusion 13000, Руководство пользователя

Страница: 127 / 228

Section 8: Using the Front Control Panel
97
6) Serial # - This establishes a S/N for USB use.
999
7) IP Address – This sets the IP Address of the laser system.
192.168l.3.4
8) Subnet Mask – This sets the Subnet mask for the laser system.
255.255.255.0
9) Gateway – This sets the Gateway for the laser system.
192.168.0.254
10) Laser - This shows which type laser is installed in the machine.
CO2
11) Vector Grid – This indicates if the Vector Grid is installed.
Yes
12) AirA Raster – This tells the machine to activate Air assist during all Raster jobs.
Yes
13) AirA Vector - This tells the machine to activate Air assist during all Vector jobs.
Yes
14) Laser Match – This sets the left-right raster line alignment.
0
15) Stamp Match - This sets the left-right raster line alignment in Stamp mode.
0
16) Set Home – This sets a new Home Position
17) Go Home – This restores the carriage lens to its standard Home position.
18) AutoF Installed – This indicates Auto Focus is installed.
Yes
19) AirA Installed - This indicates Air Assist is installed.
Yes
20) X ADJ – This calibrates the accuracy in the X-axis.
0
21) Y ADJ– This calibrates the accuracy in the Y-axis.
0
22) Laser TI – This sets the Tickle of the laser tube.
1
23) Bed Size – This indicates the bed size.
32x20
24) Sys Unit – Sets units
Inch
25) Joystick Cal – Calibrates the feel of the Joystick.
26) System Version –Firmware version.
001.000.000.001
If you are using the keyboard to change any X, Y or Focus value you will need to use the Joystick
and you will need to be careful about the correct sequence of Joystick actions.