Epilog Fusion 13000, Руководство пользователя

Страница: 118 / 228

Section 7: Quick Start & Easy Setup
88
Auto Focus
Most users prefer to use the Auto Focus capability for focusing. It’s quick and easy to
use.
Auto Focusing Through the Dashboard
Activating the Auto Focus can be done on your computer by checking the “Auto
Focus” box in the Dashboard. If there is not a Check in this box, Auto focus will
be disabled and the table will not move up or down when the job starts.
When a job is started, and Auto Focus has been enabled, the table will
automatically raise or lower to the appropriate height before the lens carriage
moves to the first point of engraving/cutting.
You must also indicate if you are using a vector grid. When the Vector Grid is
installed and you want to use Auto Focus, click the box next to “Vector Grid”.
This tells the laser system that the vector grid is installed and it will automatically
calculate the appropriate focal distance based off this information. Please note –
The material thickness is still required when using the vector grid. If a thickness is
not specified the system will auto focus to the top of the grid, not to the top of
your material.
To enter the material thickness of the object you will be engraving/marking/
cutting use a pair of calipers for an accurate measurement and enter this value in
the “Thickness” box in the driver.