EOS Emotec D, Инструкция по установке и эксплуатации

Страница: 14 / 68

14
EN
Relay box installation
The relay box may be installed only outside the cabin. Recommended installation locations are e.g.
outer wall of the cabin, plant room in order to suit the local installation situation. If empty conduits
for electrical installations are already present, this dictates the position of the relay box. Observe
the following guidelines for the installation.
WARNING
Risk to life and limb and risk of fire
Risk to life and limb from electric shock and fire in the event of improper or faulty electrical con-
nection. This risk also applies following completion of the installation work.
• Do not install relay boxes in enclosed cabinets or wood panelling.
Extending the control unit‘s control line
For extra-long connections special Sauna Bus type cables with the length 10 m, 25 m and 50 m are
available. Use the cable type RJ14/RJ10 for display panel connection and the cable type RJ12/RJ12
for a connection to a different module.
Alternatively the included Sauna Bus cable can be extended with an additional cable RJ12/RJ12 or
RJ14/RJ10 using a coupler RJ12/RJ12. For certain display panel types (e.g. EmoTouch 3)an additio-
nal power adaptor will needed is the line length is over 25 m.
The power adaptor, the extension cables and couplers sind are optionally available.
See optional accessories.
Installation works inside the cabin
At minimum, the temperature sensor, the cabin lighting and, depending on the cabin type the air
supply / air outlet, if required with a fan, must be installed in the cabin. Additional connections
are possible depending on the cabin type and selected options, e.g. additional sensors or a steam
outlet by an external vaporizer.