Endress+Hauser Liquiline Control CDC90, Руководство по эксплуатации

Страница: 64 / 118

Commissioning Liquiline Control CDC90
64 Hauser
9.3.8 Configuring program parameters
The system comprises preconfigured programs and program steps for the purpose of
monitoring, cleaning or validating the measuring points. These can be extended or
regenerated. The existing program steps should be configured during commissioning.
Adjust step times of programs
Menu
/ Setup / Program step
1. Select the Program step .
2. Enter the Duration of the Program step in seconds.
3. Go to Insert .
4. Select Replace .
 The time specified in the Program step is changed.
5. Select if the program is to run in the Automatic mode.
If the program is to run in the Automatic mode, set the following values:
1. Time interval at which the program runs (e.g. 2 W = every second week)
2. Repeat: The repetition rate of the program.
3. Start time: Should be in the present or future.
4. Click
Next and specify whether the program is a sterilization, cleaning, calibration or
regeneration program. This setting is used to evaluate the system.
To add steps after the last program, use Insert/Below. Insert/Replace does not apply
here.
Program step Edit
Under Menu / Setup / Program step it is possible to edit the pilot valves and the digital
inputs and outputs.
1. Select Settings Pilot Valve .
 The valves for the actuators can be configured here.
2. By selecting ON or OFF , choose which actuator Program step is to be activated in
this .
3. Select Digital inputs and/or Digital outputs .
 The inputs or outputs can be configured here.
4. Select Used digital input or Used digital output Off
5. By selecting ON or OFF , choose which input and output Program step is to be
activated in this .
6. If the actuator is not to be activated, set to - . This ensures that the actuator is not
switched on or off.