Endress+Hauser Liquiline Control CDC90, Руководство по эксплуатации

Страница: 73 / 118

Liquiline Control CDC90 Operation
Hauser 73
Path:Menu/Setup/Program step
Function Options Info
Sterilisation Select with checkbox The program step is used for sterilization.
Important for data analysis and system
monitoring.
Cleaning Select with checkbox The program step is used for cleaning.
Important for data analysis and system
monitoring.
Calibration Select with checkbox The program step is used for calibration.
Important for data analysis and system
monitoring.
Regeneration Select with checkbox The program step is used for regeneration.
Important for data analysis and system
monitoring.
Sample program
Here you will find an example of how a program can be compiled from program steps.
The program configured here is a typical cleaning process.
Example of a cleaning program:
1. Go to Menu / Setup / Program :
2. Enter a Program name .
3. Go to Program step .
4. Go to the first item and enter the Program step"Service position" (ID 8).
5. Enter 3 seconds as the duration.
6. Go to
Insert and select Replace .
7. Repeat the steps using the following values from the table.
8. Delete the program steps that are not required.
Position ID Name Duration in seconds
2 10 Water 120
3 4 Air 10
4 9 Cleaner 5
5 6 End 120
6 10 Water 20
7 4 Air 10
1. Configure the desired mode under Menu / Setup / Settings .
2. Allow the program to repeat twice.
3. Put a check mark beside
Program start .
After cleaning, the installation remains in the operating position. The program can be
modified by changing the step duration or by adding program steps.
Example of a clean and park program:
The program cleans the sensor and measures immediately after cleaning. In the "End" step,
the water flows continuously into the assembly. This can be used in applications where the