CF4 CF3 CF2 CF1 FW
CM1 5
4
3
2
1
SW5 SW4 SW3 SW2 SW1
STR
A 11
F 01
F 01
F 01
FUNC
Option
Code
Terminal
Symbol
Function Name
State
Description
Valid for inputs:
Required setting
C01,C02,C03,C04,C05
F01, A11 to A25
Notes:
¡
When programming the multi-speed
setting sure to press the Store key each
time and then set the next multi-speed
setting. Note that when the key is not
pressed, no data will be set.
¡
When a multi-speed setting more
than 50Hz(60Hz) is to be set, it is
necessary to program the maximum
frequency A04 high enough to allow
that speed.
Example:
¡
While using the multi-speed capability, you can monitor the current frequency
with monitor function during each segment of a multispeed operation.
There are two ways to program the speeds into the registers to
Programming using the CF switches, Set the speed by following these steps
(1) Turn the Run command off(Stop Mode).
(2) Turn each switch on and set it to Multi-speed n. Display the data section
of .
(3) Set an optional output frequency by pressing the and keys.
(4) Press the key once to store the set frequency. When this occurs,
indicates the output frequency of Multi-speed n.
(5) Press the key once to confirm that the indication is the same as the set
frequency.
(6) When you repeat operations in (1) to (4), the frequency of Multi-speed can
be set. It can be set also be parameters to
A 25
A 20
A 25
C 01
C 05
0 2
0 5
Standard operator option code
Set the parameter [ ¡ ] to [ ¡ ]
8-8
ENDA E-100
INSTRUCTION MANUAL
