Elkron MR16, Инструкция по установке и эксплуатации

Страница: 22 / 44

22 Installation and use MR16
4.1.4 Configuration of radio module MR16
Radio module MR16 operation is configured via DIP switch.
Figure 10
DIP switches Function Settings
A1 - A2 The switches arm wireless
devices acquisition and removal
steps
A1 A2
OFF OFF normal operation
ON ON acquire devices
OFF ON remove a device
ON OFF remove all devices
A3 Arm test OFF = normal operation
ON
= test procedure armed
A4 Output relay operation mode for
inputs 1÷16 OFF = bistable
ON
= monostable
A5 Output relay typology for inputs
1÷16 OFF = normally closed (NC)
ON
= normally open (NA)
A6 Output relay typology SYS ST OFF = normally closed (NC)
ON
= normally open (NA)
A7 Output relay typology ON/OFF OFF = normally closed (NC)
ON
= normally open (NA)
A8 Output relay typology SAB / RF
SAB / BAT OFF = normally closed (NC)
ON
= normally open (NA)
B1 Outputs 1÷8 subordinated to
radio module status OFF = outputs subordinated
ON
= outputs not subordinated
B2 Enable jamming detection (radio
sabotage) OFF = jamming control disarmed
ON
= jamming control armed
B3 Enable supervision
(radio sabotage) OFF = supervision disarmed
ON
= supervision armed
B4 Enable radio module MR16
buzzer OFF = buzzer enabled
ON
= buzzer disabled
B5 Enable PHYSICAL SABOTAGE
alarm OFF = physical sabotage alarm enabled
ON
= physical sabotage alarm disabled
B6 Input S polarity OFF = negative polarity
ON
= positive polarity
B7 Inhibit sirens tamper for 1 hour OFF = siren rings at tamper opening
ON
= siren does not ring if tamper is opened within
one hour from DIP switch having switched over
B8 Silence sirens audio warnings OFF = sirens do not acoustically warn about the
change of status of radio module MR16
ON
= sirens acoustically warn about the change of
status of radio module MR16
Command
Key