Elkron MR16, Инструкция по установке и эксплуатации

Страница: 12 / 44

12 Installation and use MR16
2.4 WARNINGS FROM ACTUATION DEVICES (SIRENS)
2.4.1 Siren HP500
In case of alarm command on corresponding MR16 input, siren HP500 is ringing for programmed time
duration (3, 5 or 10 minutes).
If alarm cause is still present after programmed time has elapsed, the siren does not repeat the alarm.
Siren also provides following indications when MR16 module changes its status (armed/disarmed):
Siren Flash lamp
Arm (DIP switch B8 = ON) 1 beep 2 blinking
Disarm (DIP switch B8 = ON) 2 beeps 2 sequential blinking
Disarm (siren battery low condition) 5 beeps 2 sequential blinking
Arm (siren tamper open condition) 5 beeps 2 sequential blinking
Disarm (siren tamper open condition) 5 beeps 4 sequential blinking
2.4.2 Siren IS500
In case of alarm command on corresponding MR16 input, siren IS500 is ringing for programmed time
duration (3, 5 or 10 minutes).
If alarm cause is still present after programmed time has elapsed, the siren does not repeat the alarm.
Siren also provides following indications when MR16 changes its status (armed/disarmed):
Arm (DIP switch B8 = ON)
1 beep
Disarm (DIP switch B8 = ON) 2 beeps
Disarm (siren battery low condition) 5 beeps
Arm (siren tamper open condition) 5 beeps
Disarm (tamper open siren condition) 5 beeps
2.5 CONTROL DEVICE WARNINGS
Remote control RC500 provides following warnings:
LED on The LED is lit:
•
In colour red, if a key was pressed, or
•
In colour green, if remote control battery charge level is low and the battery has to
be replaced.
Beep Radio module MR16 received and acknowledged command sent from remote
control.
Warning : beep sound level is very low and beep sound might be not heard in noisy
environments.
2.6 ARM AND DISARM MODULE MR16
2.6.1 From remote control
To arm the system:
1. Press key on remote control: remote control LED will be lit in colour red.
2. Remote control sends out a beep to confirm that radio module MR16 received the command. If it
did not, press key again to send the command again.
To disarm the system:
1. Press key on remote control: remote control LED will be lit in colour red.
2. Remote control sends out a beep to confirm that radio module MR16 received the command. If it
did not, press key again to send the command again.
2.6.2 From external control
Radio module MR16 can be armed or disarmed automatically by an external control, e.g. by wired alarm
control panel according to wired alarm control panel status.