Elkron MR16, Инструкция по установке и эксплуатации

Страница: 40 / 44

40 Installation and use MR16
8 – DEFAULT SETTINGS
System MR16 components go out of the default with following configurations:
Radio module with relay MR16
Function Programming element Default
Relay outputs 1÷8 polarisation Jumpers J1÷J8 12 V
Relay output SAB polarisation Jumper J9 12 V
Relay output RF SAB polarisation Jumper J10 12 V
Relay output BATT polarisation Jumper J11 12 V
Relay output ON/OFF polarisation Jumper J12 12 V
Relay output SYS ST polarisation Jumper J13 12 V
Acquisition DIP switch A1 OFF = normal function
Acquisition DIP switch A2 OFF = normal function
Arm test DIP switch A3 OFF = normal function
Output relay 1÷8 operation mode DIP switch A4 OFF = bistable
Output relay 1÷8 typology DIP switch A5 OFF = NC
Output relay SYS ST typology DIP switch A6 OFF = NC
Output relay ON/OFF typology DIP switch A7 OFF = NC
Output relay SAB/SAB.R/BATT typology DIP switch A8 OFF = NC
Arming operation, subordinated radio module status,
on outputs 1÷8 DIP switch B1 ON = outputs not
subordinated
Enable Jamming detection DIP switch B2 OFF = disarmed
Enable supervision (radio sabotage) DIP switch B3 OFF = disarmed
Enable buzzer DIP switch B4 OFF = enabled
Enable physical sabotage alarm DIP switch B5 OFF = enabled
Input S polarity DIP switch B6 ON = positive polarity
Silence siren tamper for 1 hour DIP switch B7 OFF = disabled
Silence sirens audio warnings DIP switch B8 OFF = disabled
Microcontact DC500
Function Programming element Default
Count shutter detector pulses Jumper J1 OFF = 5 pulses in 10 s
Internal reed contact Jumper J2 OFF = enabled
Type of external detector Jumper J3 OFF = either NC contact
or auxiliary input not
used