Eliet Edge Styler, Руководство пользователя

Страница: 48 / 76

48
English
Cleaning the machine means more than just cleaning the outside. Open all protections so that
you can also clean the concealed areas.
Special attention must be paid tot he following items:
• The cooling air intake of the motor must be spotless at all times. Ensure that none of the air
intakes are obwtructed. Vacuum clean particles, if required, that can be found behind the
intakes.
• The blade carriage guide and its driving components.
• Dirt accumulation around the parts of the wheel drive.
• Dirt accumulation on the foot pedal’s ratcheting mechanism.
• Gunk around the inside and outside of the petrol cap. Doing this prevents rubbish from con
-
taminating the petrol and ending up inside the motor.
• Rubbish on the air filter (read § 11.4.1.2.).
• Using a dry cloth, remove any dirt form the frame. Pay spec
ial attention to places where stick-
ers with safety messages are displayed. (Do not use any cleaning products that affect paint or
stickers.)
• Compressed air is a handy tool to easily blow out and, thus, clean a number of parts.
• Clean off the machine, preferably using a dry utility cloth or soft brush.
• Compressed air may also be used for cleaning off the machines. Never use compressed air at
close range of dust-tight bearings and other cap seals, etc. since the air stream can perforate
the seals.
• The machine may also be cleaned using a high pressured jet (water), in which case the utmost
care should also be taken not to dispense the water within close range of the bearings, seals,
protective coverings, and filler caps.
• When cleaning off the housing of the machine, special attention should be given to the areas
where safety warning stickers appear.
• If cleaning products are used, they shall in no way damage or corrode the warning message on
the stickers.
• Old and dirtied grease and lubricant on the drive components or hinges should be cleared off
and the parts freshly re-lubed (read § 11.5).
Caution :
Water is one of the primary causes of rusting. It is recommended to use a dry
cleaning method. Otherwise, dry off the machine and treat it with lubricant.
Caution :
Allow the machine time to cool off after operation and before attempting to
clean it. Doing so will prevent burn injuries (from the exhaust or motor).