Elettronica Santerno SINUS/ISD 200 S-0.75, Руководство пользователя, Страница: 26 / 206

15P0082B8
USER MANUAL
SINUS/ISD
3 - 12/14
3.4.1.4 Control Wiring Connections
Note:
Use screened control cables to comply with EMC requirements.
1. Feed the control cables into the inverter through the metal gland plate and connect to the control terminals.
The diagram below shows the typical control connections required for operation as a simple speed
controller.
2. Refit and secure the terminal cover using the retaining screws.
Note:
Refer to Chapter 11: “Technical Specifications” for Control Terminal information
Refer to Chapter 6: “Programming Your Application” for ANALOG INPUT and ANALOG OUTPUT
configuration switch settings.
Figure 3-12 Power Wiring and Earth Connections Figure 3-12 Power Wiring and Earth Connections
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
10k Ω
Speed
Setpoint
Run Direction
Health Relay
24V 50mA maximum
*
* Diode must be fitted across relay coil to prevent
damage to control circuit
Figure 3-13 Typical Connection to the Control Terminals Figure 3-13 Typical Connection to the Control Terminals
CONTROL TERMINALS CONTROL TERMINALS
1. 1. 0 V REF 0 V REF
2. 2. Analog input 1 (speed) Analog input 1 (speed)
3. 3. +10 V REF +10 V REF
4. 4. Analog input 2 (speed trim) Analog input 2 (speed trim)
5. 5. Analog output 2 (ramp out) Analog output 2 (ramp out)
6. 6. +24 V +24 V
7. 7. Digital input 1 (Run) Digital input 1 (Run)
8. 8. Digital input 2 (Reset) Digital input 2 (Reset)
9. 9. Digital input 3 (Direction) Digital input 3 (Direction)
10. 10. Digital input 4 (Ext Trip) Digital input 4 (Ext Trip)
11. 11. Digital input 5 (Jog) Digital input 5 (Jog)
12. 12. 0 V 0 V
13. 13. Digital output 1 (Health) Digital output 1 (Health)
14. 14. Digital input 2 (Run) Digital input 2 (Run)
15. 15. 0V 0V
16. 16. See Note A See Note A
17. 17. See Note B See Note B
18. 18. +24 V +24 V
Note A: Note A: DIGITAL INPUT 6 or ENCODER SIGNAL CHANNEL A
Nota B:
Nota B: DIGITAL INPUT 7 or ENCODER SIGNAL CHANNEL B
L1 L2/N DC+ DBR DC- M1/U M2/V M3/W
brake resistor
powersupply motor
PE1 PE2
Single Phase Input
L1 L2 DC+ DBR DC- M1/U M2/V M3/W
brake resistor
L3
powersupply motor
PE1 PE2
Three Phase Input
1 2
2 3
1 2
2
Type A
only
1
1
Brakeresistorand cablemust bescreened
if not fitted inside acontrolcubicle
Type A
only
3