ELABO G7-1G, Руководство по эксплуатации

Страница: 49 / 139

49
PC T e s t e r
9pol 25pol (female) (female) 25pol 9pol
5 7 —GND—————————— GND—— 7 5
2 3 —RxD——— ————— RxD—— 3 2
3 2 —TxD———- ———— TxD—— 2 3
7 4 —RTS———- ———— RTS—— 4 7
8 5 —CTS———- ———— CTS—— 5 8
4 20 —DTR——— ———— DTR—— 20 4
6 6 —DSR—o—-- ——o—- DSR—— 6 6
1
8 —DCD— — DCD—— 8 1
6. INTERFACES
6.2 INTERFACES
Note - driver software for PC.
Driver-software and driver-manuals are located at the ELABO Support CD,
enclosed to the device manual. The interface and the control commands
are described in the separate manual „Remote control via RS232/Ethernet".
6.2.1 Ethernet-INTERFACE X9
The Ethernet-interface is installed in the device as the standard interface.
Via interface X9, the firmware update of the touch display module is pos-
sible (see also chapter 13 ELABO Lite Software).
6.2.2 USB-NTERFACE X9
The USB-interface is installed in the device as optional interface (replace-
ment for the Ethernet-interface).
6.2.3 RS232 INTERFACE X9
The USB-interface is installed in the device as optional interface (replace-
ment for the Ethernet-interface). The 9-pin D-SUB socket X9 is provided
for the connection to a control computer. The connections DTR, DSR,
DCD are not essential necessary.
6.2.4 Service-INTERFACE X9a (RS232)
Use the service-interface X9a exclusive for updating the firmware of the
control module of the tester, via the ELABO Light Software (Chapt. 13).
The occupation of X9a see fig. 6.2.
Note: The control of the tester via X9a is not possible, use interface X9
for this.
Combi-tester G7-1G/-1H/-1T/-1U