Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 20 of 57
User Ma
nual
Vehicle Configuration
Parallel Vehicle
Chassis Pipe Sizing
To fit inside specific pipe sizes, the chassis hinges must also be adjusted. To adjust the hinges:
1. Loosen the clamping nut; make sure the camera bed is far enough forward to provide access.
2. Adjust the hinges using the indicator plaque at the back of the chassis; the sizes indicated are
internal diameters
(there is a line scribed on the main hinge that is used indicate pipe sizes).
WARNING: Pinch Hazard
– Exercise extreme caution while adjusting the track
hinges not to catch your fingers in the linkages.
3. Once the hinges are set, re-tighten the clamping nut.
Note that there are two columns of numbers on the indicator plate. STD is for the standard chassis setup,
while XT is for when the track extension plates are installed.
