Versatrax 150™
Document: UMDW014058.docm
Revision: A03
Created by: KW
Date: 10 Oct 2019
3075415-A03
Source Location: C:\ePDM\ISLEng\products\dw-versatrax150mkii\manuals\UMDW014058.docm
Page 28 of 57
User Ma
nual
FIGURE 1: 901 LIGHT INSTALLATION
– EXTENDED TRACKS
Minitrac™ Installation
To install the Minitracs
™ onto the parallel chassis, the vehicle must be configured as follows:
a. Lower the camera raise to the lowest position so the vehicle can be turned over.
b. Power the system down and disconnect the tether.
c. Remove any ballast weights.
d. Adjust the track hinges to the smallest pipe setting so that the inside screws are easily
accessible.
WARNING:
High Voltage
400 VDC.
Always make sure the system is powered
down and disconnected before performing any maintenance. 400VDC can cause
serious injury and death.
Once the vehicle is properly configured, install the Minitracs™ as shown below:
1. Lay the track onto the inner hinge as shown. The beveled ledge on the track should rest on a
step inside the hinge so that the bolt holes are at the correct height.
2. Bolt the inside link in place using 2x M6 x 16 mm SHCS and Loctite 243 (blue). Use the two rear
screw positions as shown.
STEP 1
