ECONOLITE ZincBlue2 UPS 1000W, Руководство пользователя

Страница: 84 / 92

81 | ZincBlue2 User Manual
ZincBlue2 XRT Battery 3600Wh
The ZincBlue2 XRT Battery 3600Wh is a battery controller that continuously monitor four monobloc nickel-zinc batter-
ies to make sure they are properly charged and balanced. The device has an AC (90-135Vac, 18Amp) input and 20Amp
Breaker to turn ON/OFF the AC power. Likewise, the DC Battery Output has a 50Amp Breaker to turn ON/OFF the
Battery Output port going to the UPS 1000W controller. The ZincBlue2 XRT will generally be in one of several states:
Charging (Blue LED is ON), Discharging (Green LED is ON), or Fully Charged/Battery Monitor (White LED is blinking).
A battery missing/miswired (Red LED is ON) condition can occur when one or more of the eight wires to the batteries
are missing, miswired, or a fuse has opened/blown. A system fault (Red LED is blinking) condition means the system
requires service or the battery temperature senor cable is unplugged . The ZincBlue2 XRT uses several different modes
which include Constant Current and Constant Voltage to optimize charging and balancing the batteries. The LED’s will
be BLUE or OFF during the various modes of charging that take place. The ZincBlue2 XRT communicates via CAN bus
across the battery interconnect cable with the controller. Upon loss of power, the controller will signal the ZincBlue2
XRT to enable its battery output DC bus to supply 57-43Vdc to the controller which will convert the battery DC bus to
120Vac Pure Sine wave supporting a 1000W or 1500W load the controller utilized. When not charging or discharging
the batteries will be in rest mode. When battery voltage drops below a set threshold (14.1V) due to self-discharge, the
batteries will be automatically recharged back to 100% State of Charge.
Note: In order to initiate a firmware update to the ZincBlue2 XRT, it must have all four nickel-zinc monobloc
batteries connected.
ZincBlue2 XRT Battery 3600Wh Block Diagram