ECKELMANN UA 400, Инструкция по эксплуатации

Страница: 134 / 401

Firmware V3.15 21.04.2021 134/401
Exit from the menus and operating screens
Press the ESC key to exit the menu or screen you are in at any time. This returns you to the next higher menu.
All menus and screens are closed automatically if no key is pressed for 10 minutes. The display then jumps to
the Main Menu or to the Alarm menu if any fault report is currently active (only CI 3x00 / AL 300).
8.3.2 Calling the controller menu via remote control
8.3.2.1 System Centre
The terminal for remote control of the controller (Menu 2-2 or Menu 4-2) is called in the system centre as
follows:
Step 1: Tap "2 - System overview" or "4 - Configuration" in the main menu. If "2" is selected, the values below
are only displayed as read-only, for "4", lock-down must previously be removed by logging in ( Deactivating the
input lock-down ) so that settings below can be made.
Step 2 : Tap "2 Case controllers" and select the required controller in the list that is then displayed using the
cursor buttons (↑) and (↓). In the screen that opens, the name, position designation and the alarm priority of the
controller can be input as required.
If the system centre, store computer or operator terminal remains locked down, settings on the
controller are read-only. Changes and inputs are not possible.
However, if any parametrisation is required, the lock-down for the input must be removed, see chapter
Lock-down of the setpoint change .
Tip: Detailed descriptions for the basic configuration of the controller and its position designation or
about the settings of important parameters can be found in chapter
Basic configuration of the
controller .
