EPX400-A20CU – Manual
Page 56 / 62
SERVER=server address
SERVER=
(empty string, without the
parameter)
If the role of the LTE/HSPA+ channel is sets as "Unused",
this command sets the address of the server and the role
LTE/HSPA+ channel as "Backup."
If the role of the LTE/HSPA+ channel is DIFFERENT than
"Unused" (it’s mean turned on), this command sets only the
address of the server.
Clears the server address.
NOTE: The Communicator will not attempt communication
with the server via LTE/HSPA+.
PORT=port
Server port number.
DNS1=dns1
Specifies primary DNS server address (only needed when
domain name address is used as
SERVER
address)
DNS2=dns2
Specifies secondary DNS server address (only needed when
domain name address is used as
SERVER
address)
SMS=phone number
SMS=
(empty string, without the
parameter)
If the role of the SMS channel is set as "Unused", this
command sets the phone number of the server and the role
of SMS channel as "Emergency". When there is LTE/HSPA+
failure, SMS with events will be sent to this number.
Clears the phone number.
NOTE: The Communicator will not go into SMS mode.
SMSPERIOD=time
Defines in minutes time between SMS test messages
sending to the server.
RLIMIT
Removes automatic temporary locks on all inputs
RLIMIT=inputs_mask
Removes selected automatic temporary locks. Parameter is
decimal number made from 10-bit word: A10 … A2, A1,
where A1 always equals 0, A2 means INPUT 1, A3 means
INPUT 2, and A10 means INPUT9.
EXAMPLE:
RLIMIT=6
removes locks on inputs:IN1, IN2
RLIMIT=2
remove lock on input IN1
DT=YY/MM/DD,hh:mm:ss
Sets date and time in the communicator; must be putted in
a specific format (see the table on the left)
FLUSH=x
Flushes events buffer, where
x
is:
2 – system events history
ETHSERVER=server_addres
s:port
ETHSERVER=
(tzw. empty string)
Server address and port which the communicator EPX will
connect. If the role of the channel ETHERNET was set as
"Unused" is now set to "Main".
Example:
ETHSERVER = 89.123.115.8: 9000
The command returns:
EOK - entered correctly value;
EFORMAT - incorrect format of the command;
EINVALID - if incomplete (e.g. the lack of port), or entering
other characters after “:” than numbers.
Deleting the set server address.
