EPX400-A20CU – Manual
Page 18 / 62
IP address
IP address for the LAN you want the device to work with.
IP netmask
IP address mask, default: 255.255.255.0.
Gateway
IP address of the computer in local network which mediates in connection with
communication server.
Primary / Secondary DNS
Identifies DNS addresses (the domain name system) If you provided the main or
secondary server's address as a domain, at least one DNS address must be specified.
Access Parameters
6.4.3.
In this section we define the parameters of access to the device.
Service code
6.4.3.1.
Protects the device against unauthorized access. It is used during the device
programming process and for remote control of the device (in TCP/IP or SMS mode).
The code is factory set to
1111
. You should change this code at the first
programming the device. It may contain up to seven alphanumeric characters.
6.5.
UPDATE FIMWARE
The device features a firmware update mechanism.
To flash new firmware, follow these steps:
a)
Open the file with the new firmware (click [Choose a file] to locate the
file, which should have the extension “.efi2”, e.g.
epx400-2.10.4.efi2
).
b)
Click [Send]. The firmware update process will start.
c)
After the process is complete, you will see the update status
success: “The firmware has been updated successfully.”
error: “This operation has been cancelled.”
To activate the new firmware, power on the device again or restart it.
Note: this procedure should be performed with the utmost care, as any
error, especially due to loss of power supply during the update, can result in
improper operation of the device.
