Eaton LINX, Руководство по установке

Страница: 14 / 123

S q u a r e /
R e c t a n g u l a r C o n n e c t
o r w i t h C o r n e r
Figure 2
27” high
29” high
Square/Rectangular Connector
With Corner Support
Tools Required
-5/32” Hex key (provided)
-1/4” Hex key (provided)
-Phillips head screwdriver
2. Align the two workstations in their approximate final
positions and place the
Top on the Supports. Identify
ithe corner which requires the Corner Support .
3. Remove the Top and place it, finished side down, on
a smooth, clean surface. Align the Corner Support
with the pre-drilled holes in the Top and fasten with
the #10 x 3/4” Phillips head screws. See
Figure 3 .
Figure 3
Figure 1
Hole plugs
!/4”-20 x 3/4” Phillips
head screws
Top support
Workstation
Leg
69735
1. Remove the top two plastic hole plugs from one leg
of each workstation. Assemble a
Top Support to each
workstation leg with two 1/4”-20 x 3/4” Phillips head
screws. See
Figure 1 .
NOTE : If two different height Workstations are to be
connected, assemble the Top Supports so that
they are at the same level as the lower Work-
station. See
Figure 2 .
Top
Corner Support
#10 x 3/4” Phillips
head screws
Pre-drilled holes
technical furniture
A-11