Eaton LINX, Руководство по установке

Страница: 21 / 123

Tools Required
-
Phillips head screw driver
- Level
1. Align and level the two LINX workstations to
which the Conference End is to be installed. See
Figure 1 .
2. Remove the two top hole plugs from each leg.
Next, attach the
Bracket to the legs using the four
1/4”-20 x 3/4” Phillips pan head machine screws.
See
Figure 1 . Do not tighten at this tme.
3. Attach the
Tubular leg to the underside of the Con-
ference End. Align the holes in the mounting plate
with the appropriate holes in the Conference End
and secure using the five #10AB x 1.00” Pan head
self tapping screws provided. See
Figure 2 .
4. Place the Conference end onto the Bracket. Align
the predrilled holes in the underside and fasten in
place using the #10AB x 3/4” Phillips head screws.
See
Figure 3 . Do not tighten at this time.
5. Install a Tie Plate on each side of the Conference
End using the #10AB x 3/4” Phillips head screws.
See
Figure 3 .
6. Adjust alignment of the worksurfaces and tighten
all screws.
Conference End
Figure 1
Figure 2
Bracket
LINX workstations
Hole plug
1/4”-20 x 3/4” Phillips
head machine screws
84252
C o n f e r e n c e E n d
technical furniture
A-16
Figure 3
Bracket
Tie plate
#10AB x 3/4” Phillips
head screws
Conference end
Tubular leg
Conference end
#10AB x 1.00 pan head
self tapping screws
Pre-drilled holes