Eaton LINX, Руководство по установке

Страница: 22 / 123

P e n i n s u l a , B o l t - o n
1. Position the two Linx Workstations to which the
Bolt-on Peninsula is to be attached approximately
30” apart. See Figure 1 .
2. Remove the top two plastic hole plugs from one leg
of each workstation. Assemble a
Top Support to each
workstation leg with a 1/4”-20 x 3/4” Phillips head
screw.
Do not fully tighten the screws at this time. See
Figure 2 .
NOTE : If two different height Workstations are to be
connected, assemble the Top Supports so that
they are at the same level as the lower Work-
station. See
Figure 3 .
Peninsula, Bolt-On
Figure 1
Figure 3
30”
Linx Workstations
27” High
29” High
Tools Required
-5/32” Hex key (provided)
-1/4” Hex key (provided)
-Phillips head screwdriver
84913
Figure 2
Top support
Hole plugs
1/4”-20 x 3/4” Phillips
head screw
Adjoining workstation
technical furniture
Top support
A-17