Eaton LINX, Руководство по установке

Страница: 37 / 123

86270LX
3. Turn the assembly upright and position it underneath
the viewport cutout in the Worksurface. Align the
holes in the Top Rails with the corresponding holes in
the Worksurface and attach with the #14AB x 3/4”
screws provided. See
Figure 3 .
4. Attach the
Tracks to the to the underside of the
Worksurface by aligning the holes in the Tracks with
the corresponding holes in the Worksurface (or
stiffener on a 30” Linx Worksurface) and securing
with the #6AB x 5/8” screws provided.
Note : One end
of each Track is painted black; this end must be to the
front of the Worksurface. See
Figure 4 .
Install a
Rubber Stop in the center hole at the rear of
each Track with the #6AB x 5/8” screws provided.
5. Install the
Keyboard Drawer by sliding the two
brackets into the Tracks installed in step 5. Push the
Drawer all the way to the rear of the Tracks and in-
stall a Rubber Stop in the center hole at the front of
each Track with the #6AB x 5/8” screws provided.
See
Figure 5 .
Figure 4
Figure 5
R e t r o f i t K i t
N o v a ( c o n t . )
technical furniture
Figure 3
#14AB x 3/4”
screw
Worksurface
Viewport cutout
Retrofit assembly
Rubber stop
#6AB x 5/8”
Screws
Tracks
Stiffener
Worksurface
#6AB x 5/8”
Screws
Rubber stop
Keyboard drawer
Worksurface
Tracks
Brackets
#6AB x 5/8”
Screw
A-30