Eaton LINX, Руководство по установке

Страница: 35 / 123

W o r k s t a t i o n C a b l e
M a n a g e m e n t ( c o n t . )
Figure 4
Wire Cover
Modesty Panel
Leg
Figure 6
Wire Cover
Leg
Exit from Modesty
Panel
Cable
Figure 5
Cable port
Bottom of Wire
cover
WIRE COVERS
The
Wire Covers are attached to the rear of each work-
station leg and vertically route cables from the Modesty
Panel down the rear of the leg. Cables and wires can
exit at the bottom of the Wire Cover.
Wire Covers are left
and right hand with pre-punched
access areas at the top and a removable port at the bot-
tom. See
Figure 3 .
NOTE : Wire Covers for add-on Corner Workstations
are common. (No right or left hand).
To route cables thru the Wire Cover :
1. Remove the desired Wire Cover from the back of the
leg by squeezing the outer surface inward to disengage
it from the leg. Start at the top and work downward.
See
Figure 4 .
2. Using a knife, remove the cable port from the bottom
of the Wire Cover. See
Figure 5 .
3. Route the cables and re-install the Wire Covers. See
Figure 6 .
4.
Cable Clips are provided for additional cable manage-
ment as required. See Figure 7.
Right Hand Wire Cover
Figure 3
Left Hand Wire
Pre-punched access
holes
Removable port
Figure 7
Cable Clip
Cable
84566
technical furniture
A-28