Eaton LINX, Руководство по установке

Страница: 12 / 123

S q u a r e /
R e c t a n g u l a r C o n n e c t
o r w i t h
The 30” x 24” and 36” x 30” connectors have
only one cable bushing. The longer Modesty
Panel should be installed on this side. See
Figure 4 .
Square/Rectangular Connector
With Modesty Panels
Figure 1
Figure 2
27” high
29” high
Tools Required
-5/32” Hex Key (provided)
-1/4” Hex Key (provided)
-Phillips head screwdriver
84570
1. Remove the top two plastic hole plugs from one leg
of each workstation. Assemble a
Top Support to each
workstation leg with a 1/4”-20 x 3/4” Phillips head
screw.
Do not fully tighten the screws at this time. See
Figure 1 .
NOTE : If two different height Workstations are to be
connected, assemble the Top Supports so that
they are at the same level as the lower Work-
station. See
Figure 2 .
2. The Modesty Panel is installed from the rear and
fits between the Top Supports and the Corner Leg.
Fasten it with four 1/4”-20 x 3/4” Phillips head
screws. Tighten all screws. See
Figure 3 .
NOTE : If the 26” high Modesty Panel is being installed,
use six 1/4”-20 x 3/4” Phillips head screws.
Hole plugs
!/4”-20 x 3/4” Phillips
head screws
Top support
Workstation
Leg
Corner leg
Top support
!/4”-20 x 3/4” Phillips
head screws
12”/26” Modesty
panel
Figure 3
technical furniture
A-9