Eaton LINX, Руководство по установке

Страница: 80 / 123

P a s s - T h r o u g h
O r g a n i z e r s ( c o n t . )
2. Install a Mounting Bracket at each corner of the
worksurface with the #10 x 3/4” Phillips pan head
screws provided. See
Figure 3 .
3. With two people, carefully lift and place the Organizer
on the worksurface with the bottom of the Uprights
fitting down over the Mounting Brackets.
Secure the Uprights to the Mounting Brackets with the
four 1/4”-20 x 1/2” Button head cap screws provided.
Tighten the screws with the 5/32” Allen wrench. See
Figure 4 .
4. Install the two
Top Caps . See Figure 4 .
IMPORTANT! The Linx Organizer must be fastened
to the worksurface.
FASTENING THE ORGANIZER TO A LINX
WORKSURFACE
Figure 3
#10 x 3/4” Phillips
pan head screws
Mounting brackets
69299
technical furniture
1. Using the cardboard Drill Template provided, drill two
1/8” diameter holes approximately 1/2” deep into the
two corners of the Linx Worksurface as shown in
Figure 2 .
Carefully fold the template along perforations and place
the template on the corner of the worksurface as shown
in
Figure 2 .
Fold the tab on the opposite end of the template for the
other corner of the worksurface.
Figure 2
Drill template
Corner of worksurface
Perforations
Figure 4
Organizer
upright
1/4”-20 x 1/2” Button
head cap screws
Top cap
Worksurface
D-13